It is highly recommended that your
water heater is mounted on a stand. All Loheat water heaters are
fitted with integral flanges only to tie the units back to the
wall for added security. These flanges are not designed to support
the weight of the heater for wall mounting.
We advise the use of these strong
galvanised stands to both increase the effectiveness of your water
heater and prolong its life. Safely elevating the heater to the
required / optimum level, the stand also distributes the weight of
the heater over the entire base, preventing any warping or bowing
that can occur when heaters are supported on bricks or pillars. All stands are supplied in flat pack kit
form for easy self assembly, which only takes minutes.
Don't forget all heaters are gravity
discharge, so the outlet needs to be higher than the wash trough
or sink.
-
16 gauge steel tray
to fully support the base of the water heater.
-
14 gauge steel legs
for compressive strength.
-
Folded back foot
pattern for high load bearing.
-
Loheat special leg
clamping flanges for rigidity.
-
Handy storage tray
for above floor storage of chemicals etc.
-
Available in 3
heights for every size of heater.
-
Easy assembly with
no specialist tools required.
| MODELS 65 - 225
LITRES |
|
|
LEG HEIGHTS |
PART NUMBER |
| 500mm |
LST1 |
| 800mm |
LST2 |
| 1100mm |
LST3 |
| |
|
|
MODELS 295 - 680 LITRES |
|
| 500mm |
LST4 |
| 800mm |
LST5 |
| 1100mm |
LST6 |
All stands are carriage free if
ordered at the same time as a water heater.
click on buy for current pricing
 |
